NEC SV8500, Manual

Page: 411 / 3438

VOL.2-158
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
5.4.5 How to Use Maintenance Command
Note:
“SIP server” used in this section refers to the Telephony Server. The Telephony Server acts as SIP server
for 8LC Card using Proprietary Protocol.
Note:
When 8LC Card reboots itself due to such as an occurrence of health check timeout while maintenance
commands are executed, it takes about five minutes to start rebooting.
On a serial connection client (e.g. HyperTerminal), start up the program and use maintenance command. Enter
“usrConsole” after the OS prompt (->).
When the maintenance command is started, the following prompt is indicated on the screen:
MC(SIP)>_ (“machine name” + “>”, usually)
An example of indication is shown below:
MC-ID: 00301caf2c1d
Boot program version
Main program version
H/W PKG information
H/W PKG information
DSP information
DSP information
:SP3839 SH7751R CBOOT-1 PROG-A [03.00.00.00]
:SP3893 8MC PROG-A [01.00.00.00]
:CA-CC12 3A
:PZ-CC171 2A
:DSP-K-AC49kernel [01.07.06.00]
:DSP-P-AC490012ae3 [01.07.07.02]
Starting Boot program.......
--- Online program Initial start (Wait for a while) ---
Attached TCP/IP interface to dp unit 0
Attaching interface lo0... done
Adding 10292 symbols for standalone.