NEC SV8500, Manual

Page: 1654 / 3438

VOL.2-1401
MG-SIP128 [MG-128SIPMGG]
When Session-Timer is Disable (=1) is selected:
Note:
Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGG] connects.
(47) signaling_port_no
Setting of the UDP port number that receives control signal packets
This command is used to specify the UDP port number that receives the control signal packets.
[Setting Example]
Note:
Normally this command is not required to be changed.
(48) sip_accfilter
Setting of SIP Access Filter
This command is used to enable the SIP Access Filter which discards SIP packets received from an un-
authorized destination.
Also, this command is used to enable the Burst Access Filter which temporarily limits the maximum num-
ber of incoming calls that can be received by a Telephony Server when a rush of calls from a SIP network
occurs instantaneously.
[Setting Example]
When IP address (=0) is selected by “set sip_server” command:
[IPv6]
MG(SIP) > set session_timer
Select the setting of Session-timer.
0=enable(default)
1=disable
Input:1
MG(SIP) > set signaling_port_no
Input Signaling Port Number.
(1024-65535(default=61012)):61012 Assign the UDP port number that receives the con-
trol signal packets (Default: 61012).
MG(SIP) > set sip_accfilter
Select the setting of SIP Access
Filter.
0=disable (default)
1=enable
Input: 1
Enable/disable SIP Access Filter.
0: SIP Access Filter is disabled (default).
1: SIP Access Filter is enabled.