NEC SV8500, Manual

Page: 1361 / 3438

VOL.2-1108
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
24. SET
Δ
PRI_T1_2
Δ
[ P1 ]
This command is used to specify alarm and signaling data for PRI (1.5M). To make this assignment effec-
tive, it is required to execute the “SAVE” command and to restart before exiting the maintenance command.
When P1 is not entered:
When P1=1000:
MG-PRI(SIP)>SET PRI_T1_2
Remote Alarm
(0/1: 0):0
1) Specify Remote Alarm
0 =Data Link, Fs bit (default)
1 =In Channel
Alarm Operation Mode (0/1: 0):0
2) Enable/Disable Alarm Operation Mode
0/1= Enable (default)/Disable
Alarm Release Timing (0/1: 0):0
3) Specify Alarm Release Timing
0 =Short (default)
1 =Long
Alarm Detect/Release Type (0/1: 0):0
4) Specify Alarm Detect/Release Type
0 =Normal (default)
1 =AT&T
Line Signal (0/1: 0):0
5) Specify Line Signal
0 =Binary 8 Zero Substitution (B8ZS) (default)
1 =Alternate Mark Inversion with Zero Code
Suppression (AMI ZCS)
Multi Frame (0/1: 0):0
6) Specify Multi Frame
0 =24 Multi Frame (default)
1 =12 Multi Frame
Signaling In Channel (0/1: 0):0
7) Specify Signaling in Channels
0 (fixed)
Dch Mode (0/1: 0):0
8) Specify Dch Mode
0 =ITU-T (default)
1 =AT&T
Equalizer (0-4: 0):0
9) Specify Equalizer
0 =0-40m (default)
1 =41-80m
2 =81-121m
3 =122-161m
4 =162m or more
set value is 0x0000
setting succeeded.
Result is displayed.
MG-PRI(SIP)>SET PRI_T1_2 0000
P1 -Specify a set value
0000-FFFF = Set value (default value: 0000)
set value is 0x0000
setting succeeded.
Result is displayed.