NEC SV8500, Manual

Page: 1743 / 3438

VOL.2-1490
MG-SIP128 [MG-128SIPMGJ]
set Command
(1) 183rbt
Setting of local RBT connection select function when receiving 183 message (w/o SDP)
This command is used to enable/disable the connection of local RBT when 183 message without SDP is
received.
[Setting Example]
Note: The conditions of this command are as follows.
• Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGJ] connects.
• Normally this command is not required to be changed.
(2) 184toprivacy
Setting of switching Caller ID display/blocking to SIP network function when dialing 184/186
This command is used to set the function to delete 184/186 by MG-SIP128 [MG-128SIPMGJ] when di-
aling 184/186. When this setting is enabled, if a user adds 184/186 at the beginning of the dialing num-
bers, MG-SIP128 [MG-128SIPMGJ] deletes the 184 (non-Caller ID) or 186 (Caller ID) from the dialed
numbers, and transmits the message to SIP network.
[Setting Example]
When Pattern 1 is set: Performs forced non-Caller ID for 184, forced Caller ID for 186. (The first three
digits of the dialed numbers (184/186) are to be deleted.)
When Pattern 2 is set: Performs forced non-Caller ID for 184, forced Caller ID for 186. (The first three
digits of the dialed numbers (184/186) are not to be deleted.)
Note: Assign this command adjusting to the specifications on the SIP network where MG-SIP128 [MG-
128SIPMGJ] connects.
MG(SIP) > set 183rbt
Select mode of RBT Addition when MG(SIP)
receives 183 without SDP.
0=enable(default)
1=disable
Input:0
Enter 0 or 1 (Default=0).
0: Enable
1: Disable
MG(SIP) > set 184toprivacy
Select privacy function of 184.
0=disable(default)
1=Pattern 1
2=Pattern 2
Input:0
0: Switching is disabled (default)
1: Switching is enabled. (Pattern 1)
2: Switching is enabled. (Pattern 2)