NEC SV8500, Manual

Page: 948 / 3438

VOL.2-695
MG-COT Card [SCA-6COTB]
6. Setting ToS of DRS session
Note:
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
followed by the prompt. The meaning of 1-byte data is shown below:
Note:
The designated DRS ToS cannot be applied when SP mode. Assign the Proprietary Protocol mode before
executing this DRS ToS setting.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
MG-COT > SET DRSTOS PRECEDENCE
PRECEDENCE (0-7) : 6
DELAY (0/1) : 0
THROUGHPUT (0/1) : 0
RELIABILITY (0/1) : 0
COST (0/1) : 0 Line 1: Enter sub command name
PRECEDENCE to set the
parameters such as Delay,
Throughput, Reliability, and
Cost. Specify the value to each
parameter.
Line 2: Precedence:0-7(low-
high)(default=6)
Line 3: Delay:0/1=Nomal(default)/Low
Delay ON
Line 4: Throughput:0/
1=Nomal(default)/High
Throughput ON
Line 5: Reliability:0/1=Nomal(default)/
High Reliability ON
Line 6: Cost:0/1=Nomal(default)/Cost
Precedence ON
DRS TOS setting succeeded.(0xC0) Line 7: Result is shown.
MG-COT > SET DRSATOS VALUE
TOS (00-FF) : C0 Line 1: Enter the sub command name
VALUE to set the DRS setting
value Directly.
Line 2: Specify the value in the range of
00-FF(default=C0).
DRS TOS setting succeeded.(0xC0) Line 3: Result is shown.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Prec.
D T R C