NEC SV8500, Manual

Page: 2044 / 3438

VOL.2-1791
MG-SIP16 [SCA-16SIPMGA/MG-16SIPMGA]
21.4.4 Configuration Command Assignment
Assign the configuration data by command operation on the maintenance console.
Note:
“DRS (Device Registration Server)” used in this section refers to the Telephony Server. The Telephony
Server acts as DRS for MG-SIP16 using Proprietary Protocol.
The following message is displayed on the Maintenance Console screen.
Note 1
Note 1:
If the CONSOLE cable is connected after starting up the MG-SIP16, “->” prompt will not appear. In this
case, press Enter key to display “->” prompt.
Note 2:
MAC address that you need to register on “Data Assignment by PCPro”.
Note 3:
When downloading a firmware, an initialization is required to display the version of the downloaded firm-
ware.
Note 4:
To confirm the configuration information:
Press ESC key within five seconds after “Main Program Start...” to display “->” prompt. Then, input
“config” to go into the configuration mode. (However, registration to the Telephony Server is not executed.
Note:
If the key control is not activated, a communication problem between the console and the MG-SIP16 might
occur. Make sure the connector is firmly inserted.
DP OK [N]
MG-ID: 000064e9a6b1
MG-ID: 000064e9a6b2
Boot program version : SP3839 SH7751R CBOOT-1 PROG-A [04.00.00.00]
Main program version : SP3905 SIP MG(16) PROG-A [01.00.00.00]
H/W PKG information : CA-CC10
DSP information : Not detect information.
Starting Boot program.....
--- Online program Initial start (Wait for a while.) ---
Attaching interface lo0...done
Adding 6009 symbols for standalone.
Main Program Start.....
Press Enter Key.
please setting config data!!
MAC address of Ether1
Note 2
MAC address of Ether2
BOOT program name/version
MAIN program name/version
Note 3
hardware name/version
Note 4