NEC SV8500, Manual

Page: 842 / 3438

VOL.2-589
MG-COT Card [SCA-6COTA/SCA-6COTC]
5. Setting IP address and port number of DRS
Note:
The designated DRS setting cannot be applied when SP mode. Assign the Proprietary Protocol mode before
executing this DRS setting.
Note:
The value in [ ] shows the current setting. Press enter key to apply the current setting shown in [ ].
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
Note 1:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
6. Setting ToS of DRS session
MG-COT > SET DRSADDRESS
DRS Unit (1:Primary/2:Secondary/3:Tertiary/
4:Forth) : 1
DRS IP Address [0.0.0.0] : 150.10.1.100
DRS Port Number (1024-65535) [3456] : 3456 Line 2: Select “1” for the Telephony
Server in normal condition.
Line 3: Enter IP Address of DRS. (e.g.
150.10.1.100)
Note 1
Line 4: Enter Port Number of DRS
(1024-65535, default = 3456).
DRS setting succeeded. Line 5: Result is shown.
MG-COT > SET DRSTOS PRECEDENCE
PRECEDENCE (0-7) : 6
DELAY (0/1) : 0
THROUGHPUT (0/1) : 0
RELIABILITY (0/1) : 0
COST (0/1) : 0 Line 1: Enter sub command name
PRECEDENCE to set the
parameters such as Delay,
Throughput, Reliability, and
Cost. Specify the value to each
parameter.
Line 2: Precedence:0-7(low-
high)(default=6)
Line 3: Delay:0/1=Nomal(default)/Low
Delay ON
Line 4: Throughput:0/
1=Nomal(default)/High
Throughput ON
Line 5: Reliability:0/1=Nomal(default)/
High Reliability ON
Line 6: Cost:0/1=Nomal(default)/Cost
Precedence ON
DRS TOS setting succeeded.(0xC0) Line 7: Result is shown.