NEC SV8500, Manual

Page: 414 / 3438

VOL.2-161
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
COMMAND No. SUB COMMAND FUNCTION REMARKS
SHOW
1 BURSTPATTERN To show Burst Ringer Pattern setting:
2 CH_ATTRIBUTE To show Channel Attribute:
3 CID_SEND_WAIT To show Caller ID Send Wait Timer:
4 CODEC_COEF To show CODEC Coefficiency:
5 CONFIGDATA To show configuration data list:
6 DHCP To show DHCP:
7 DNS_SW To show DNS Server:
8 DSP_ECFB To show DSP echo canceller for FAX communication:
9 EC_TRAINING To show echo canceller training:
10 FAXERRORDETECT To show FAX enable timer:
11 FAXRECVPAD To show Fax receiver PAD value:
12 FAXSENDPAD To show Fax sender PAD value:
13 HC_TIMER To show Health Check Receive Timer
14 INTERFACE To show the communication speed for LAN interface:
15 IPADDRESS
To show IP address, Subnet Mask, and Default Gateway of
8LC Card:
16 MUSICTYPE To show Internal Music-on-Hold type:
17 MW_LAMP To show Message Waiting Lamp control type:
18 ONE_TIME_PASS To show One Time Password for security:
19 OPEN To show Open/Reverse mode:
20 OWN_NAME To show Host Name of 8LC Card:
21 PAD To show default receiver PAD value:
22 PRERINGING To show Pre-Ringing:
23 RINGFREQ To show Ringer Frequency:
24 SENDPAD To show default sender PAD value:
25 SIGNALING_PORT_NO To show signaling port number for SIP:
26 SIGNALING_QOS To show QoS setting for SIP signaling session:
27 SIPSV_IPADDRESS
To show IP address, port number, and host name of SIP serv-
er:
28 SMOOTH_PAD To show DSP smooth PAD mode:
29 STARTPORT To show RTP Start Port:
30 STATUS To show operating status of 8LC Card:
31 STUTTERDT To show Stutter Dial Tone:
32 SYNCRINGING To show Synchronous Ringer mode:
33 VERSION To show firmware and hardware version:
34 VLAN To show VLAN:
35 WARNING_TONE To show Warning Tone for LAN failure:
COMMAND SUB COMMAND FUNCTION REMARKS
PING - To check the connection status of network:
COMMAND SUB COMMAND FUNCTION REMARKS
DELETE VLAN To delete the VLAN setting: