NEC SV8500, Manual

Page: 1460 / 3438

VOL.2-1207
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
Input the desired command, sub command and each required parameter after the prompt (“MG-PRI(SIP)>” as
an example here) is indicated. Parameters vary depending on the specified command. When each data (com-
mand name, sub command name, parameter) is specified correctly, the command executes the required data pro-
cessing, and then informs of the processed result on the screen. When finishing this program, you may input
“EXIT” (or “exit”) after a prompt.
Note:
When the maintenance command program is activated, it also provides help function for referring to avail-
able command and sub command. After a prompt is indicated, request to list up the target help by inputting
“?”, “command name + ?”, or “command name + sub command name + ?” after the prompt, and press
the Enter key.
The example below shows the screen when executing help function regarding “set” and “set ipaddress.”
MG-PRI(SIP)>set
?
Address
Interface
:
:
Setting IP address
Setting Interface Information
MG-PRI(SIP)>set ipaddress ?
xxx.xxx.xxx.xxx IP Address
MG-PRI(SIP)>set ipaddress 10.41.204.180 ?
xxx.xxx.xxx.xxx Subnetmask
MG-PRI(SIP)>