NEC SV8500, Manual

Page: 570 / 3438

VOL.2-317
MCMG [SCA-4LC2COTA/MG-4LC2COTA]
17. There are the following restrictions when using REMOTE ACCESS TO SYSTEM [R-2] or AUTO-
MATED ATTENDANT [A-82].
• If Virtual Register cannot be seized, Physical Register is seized. (i.e. RT=902 ORT, RT=903 IRT,
RT=906 PBR for Automated Attendant Service, RT=933 CRT)
• When Virtual/Physical (described above) Register cannot be seized, calling party hears busy tone.
• A maximum of 60 Virtual Registers can be used per 1 LP at the same time.
• Assign “2” to EQP of AAED to make calling party hear some announcement. The announcement can
be sent only once.
Note 1
Note 1:
“8” or “9” must not be assigned to EQP.
18. System Messages ([33-R], [33-T]) are output when packet transmission failure is detected in Internal PHI-
BRI.
19. Assign the following parameters in ARTI command when using fax via MG.
• CDN 71: IP FAX data
• CDN 72: Jitter Buffer Size for IP FAX
• CDN 73: Payload Type for IP FAX
• CDN 74: Payload Size for IP FAX
20. When analog terminal is connected to outside via MG, the terminal user can send external/internal music
resources as Music-on-Hold. External/internal Music-on-Hold data is assigned by AMGIL command per
MG.
21. MCMG does not support Caller ID Display (Number Display). When connecting a terminal having its
function to MG, turned off the function of the terminal.
22. When Trunk Soft Hold Timer is effective, the call originating party will be charged when the timer
expires.
23. A Conference cannot be established until the False Answer Timer expires.
24. SMDR cannot be collected until the False Answer Timer expires.
25. Adding a pause when originating to Central Office Line is available since FP85-105 S2. The conditions
are below:
• The required firmware is the following: SP-3778 MCMG PROG-A Issue 16 or later/SP-3927 MCMG
PROG-B Issue 5 or later.
Note 2
• The features which can be added a pause are the followings:
(1) Speed Calling - System [S-3] / Speed Calling Override - System [S-61]
(2) Speed Calling - Station [S-21]
(3) All features which use the additional digits information by AACD command.
(4) Last Number Called - D [L-6D]
Note 3
• A pause which is inserted per one pause is about three seconds.
• Multiple pauses can be inserted. For the number of the digit which can be inserted, see each feature
conditions.