NEC SV8500, Manual

Page: 2943 / 3438

VOL.3-456
CHAPTER 4 CONFIGURATION SETUP
1.4.11 How to Set Language for Time Display
To set language for Time Display of DtermIP/IP Enabled Dterm, follow the procedure below.
The following languages are supported by each terminal:
• IP Enabled Dterm (Dterm Series E/Dterm 75): Automatic (according to the System Data setting), English,
Portuguese, Spanish, French
• IP Enabled Dterm (Dterm Series i), DtermIP: Automatic (according to the System Data setting), English, Por-
tuguese, Spanish, French, German, Italian, Dutch, Norwegian, Danish, Swedish
STEP 2: Open the Administrator Menu by pressing "Hold"+"#"+"0" on the User Menu.
STEP 1: Open the User Menu by pressing "Hold"+"Transfer"+"*"+"#" while the terminal is in normal operation,
indicating an error message or "DHCP Connecting.../DRS(1st) Connecting..." on the display.
1. DtermIP Mode
2. Download Address
Up Down
Exit
1. DtermIP Mode
2. Download Address
3. Area ID
4. Port
5. Download
6. SoftReset
7. Factory Value
8. Type of Service
9. Language
0. Next Page (P1 >> P2)
Administrator Menu List
Up
Down
[Administrator Menu]
1. DHCP Mode
2. DRS Address Primary
Up Down Save Cancel
[User Menu]
Two items are displayed on the terminal.
The following Administrator Menu is displayed.
A
*. Automatic
0. English/Japan
Up Down Cancel OK
STEP 3: Select "9. Language" by pressing "9" on the menu. The display changes as follows.
Up
Down
Language Items
*. Automatic
0. English/Japan
1. Portuguese
2. Spanish
3. French
4. German
5. Italian
6. Dutch
7. Norwegian
8. Danish
9. Swedish
Note:
When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".