NEC SV8500, Manual

Page: 1573 / 3438

VOL.2-1320
MG-T1(SIP) [SCA-24DTIA]
• When P1=CLEAR is entered to delete the current QoS setting:
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
Note:
The value in ( ) shows the current setting.
F
To set in dialog format (press Enter key after the sub command to skip entering P1 and P2):
• When TOS is selected in QoS setting, assign the data in IP Precedence type:
• When DIFFSERV is selected in QoS setting, enter the setting value in DSCP type:
MG-T1(SIP) SET SIGNALING_QOS CLEAR P1 : Enter CLEAR to clear QoS setting
Signaling QoS clearing succeeded.(0x00) Result is shown.
MG-T1(SIP)> SET SIGNALING_QOS
QOS(TOS/DIFFSERV: TOS): TOS
PRECEDENCE (0-7:6): 6 Specify the precedence in IP network.
0-7 =the precedence in IP network (Default:6)
DELAY (0/1: 0): 0 Enable/Disable Low Delay Precedence in IP network.
0 =Disabled (Default)
1 =Enabled
THROUGHPUT (0/1: 0): 0 Enable/Disable Throughput Precedence in IP network.
0 =Disabled (Default)
1 =Enabled
RELIABILITY(0/1: 0): 0 Enable/Disable Reliable Precedence in IP network.
0 =Disabled (Default)
1 =Enabled
COST (0/1: 0): 0 Enable/Disable Low Cost Precedence in IP network.
0 =Disabled (Default)
1 =Enabled
Signaling QoS setting succeeded.(0xC0)
MG-T1(SIP)> SET SIGNALING_QOS
QOS(TOS/DIFFSERV:DIFFSERV): DIFFSERV
DSCP(0-63: 48): 48
Specify a Differentiated Service Code Point (DSCP)
value.
0 - 63 =DSCP value (Default:48)
Signaling QoS setting succeeded.(0xC0)