NEC SV8500, Manual

Page: 901 / 3438

VOL.2-648
MG-COT Card [SCA-6COTB]
SIZE
Setting of PAD
Click this check box when setting data for PAD value of MG.
PAD Information
This parameter is available only when the check box of “Setting of PAD” is ON.
No = 1: The PAD value of MG when DtermIP/Soft Phone/INASET is connected
No = 2: The PAD value of MG when Analog MC/Digital MC is connected
No = 3: The PAD value of MG when IPPAD is connected
No = 4: The PAD value of MG when MG is connected
Note:
The PAD value of MG (6COT) is valid only when you select “Setting”from the drop-down box of “Setting
of Detail” to specify the detail PAD value.
AIVCL: Assignment of IP Service Voice Control Data (LDM)
Assign the voice packet control data for terminal that is connected to MG (6COT).
A LOC-ID
Location ID of MG (6COT) or IP terminal
B LOC-ID Location ID of MG (6COT) or IP terminal
SETTING OF JITTER BUFFER
JB_MIN:Jitter Buffer Minimum
JB_MAX:Jitter Buffer Maximum
SETTING OF TYPE OF SERVICE (VOICE PACKET)
Type of service for MG (6COT)
SETTING OF PAYLOAD
PAYLOAD TYPE
PAYLOAD SIZE
ALOCL: Assignment of Location ID Data (LDM)
Each IP terminal is allocated a Location ID to identify its location within the network on Network Address
basis. By using the Location ID, IP services such as Bandwidth Control and ToS Control are provided for
each IP terminal. Select “Network Address” radio button in ALIDL command.
TYPE: Select “Network Address”.
IP ADDRESS: Enter the IP Address. For the Telephony Server (IPPAD), assign “0.0.0.0”.
MASK BIT: Enter the Mask Bit in the range of 1-31 except when IP Address 0.0.0.0 is determined. Mask
Bit=32 is automatically set when IP Address=0.0.0.0
NETWORK ADDRESS: Display only.
LOC-ID:
Assign the Location ID in the range of 0-4095, associated with the IP Address. When IP Ad-
dress=0.0.0.0, LOC-ID=0 is automatically set (the value cannot be changed).
Note:
LOC-ID=0 is predetermined to the Location ID of the Telephony Server (i.e.IPPAD).
Setting Type of Signaling Packet Service: Click the check box to assign the ToS for signaling packet.
IP PRECEDENCE/DIFFSERV:
<When IP PRECEDENCE is selected>
Priority: Specify the precedence in the range of 0-7 (low-high).
Low Delay: Place a checkmark to set Low Delay to ON.
Through Put: Place a checkmark to set High Throughput to ON.