NEC SV8500, Manual

Page: 1148 / 3438

VOL.2-895
MG(BRI) [SCA-2BRIA/MG-2BRIA]
• When assigning the time-out value for RTP_STOP_DETECT.
Note 1
,
Note 2
,
Note 3
Note 1:
Assign this value as one of the conditions for MG Based Call Retention to determine that the call is re-
leased. The call will be determined released if RTP is not received exceeding the assigned time-out value
during call retention.
Note 2:
“CONFIG RTP_STOP_DETECT” must be entered in upper case letters.
Note 3:
Execute the “SAVE” command before finishing the maintenance command to reflect change.
17. SET VLAN
Assign the Tag VLAN information.
Note:
Execute the “SAVE” command before finishing the maintenance command to reflect change.
Note:
Do not assign the following addresses (network address, broadcast address) to MG(BRI).
(example)
- IP address 192.168.1.0/Subnet mask 255.255.255.0 (192.168.1.0 is network address, improper)
- IP address 176.16.0.0/Subnet mask 255.255.0.0 (176.16.0.0 is network address, improper)
- IP address 192.168.1.255/Subnet mask 255.255.255.0 (192.168.1.255 is broadcast address, improper)
- IP address 176.16.255.255/Subnet mask 255.255.0.0 (176.16.255.255 is broadcast address, improper)
As IP address of MG(BRI), Default Gateway, and SIP server is gotten by DHCP server, there is no need to
assign these network data on MG(BRI) side. IP addresses listed below, however, need to be assigned on
DHCP server side.
Note 1
• IP address of Default Gateway
• IP address of SIP server
Note 2
,
Note 3
MG-BRI>set VALUE CONFIG RTP_STOP_DETECT P1 P1:
Time-out value for
RTP_STOP_DETECT.
Effective range: 3-32 seconds
(default: 3 seconds)
Configuration data was changed into ‘P1’.
In order to make a setup reflect. re-starting is
required after saving a configuration data
by SAVE command.
MG-BRI>set vlan
VLAN_ID(0-4094):1
VLAN ID: 0-4094 (default: 0)
COS(0-7):6 CoS setting: 0-7
IP Address:10.41.1.200 IP address of VLAN
Subnet mask:255.255.255.0 Subnet mask of VLAN
Default configuration is ‘Not use VLAN/VLAN ID=0’,
if you will not change a configuration by using this command.
In order to make a setup reflect and keep, re-starting is
required after saving a configuration data by SAVE command.