NEC SV8500, Manual

Page: 521 / 3438

VOL.2-268
MC & MG with PFT
SET COMMAND (MC side)
1. Setting Burst Ringer Pattern:
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
2. Setting CODEC Coefficient:
Note:
The setting values are shown in the following table.
• North America
• Australia
RESISTER KIND OF BNW SETTING VALUE
600
Ω
600
Ω
0 (default)
600
Ω
350
Ω
+(1000
Ω
//210nF) 1
RESISTER KIND OF BNW SETTING VALUE
220 Ω +(820 Ω //120nF) 600 Ω 0 (default)
220 Ω +(820 Ω //120nF) 220 Ω +(820 Ω //120nF) 1
600 Ω 600 Ω 2
Line 1: Select the Ringer Pattern from the following:
1: 0.35 seconds ON - 0.3 seconds OFF - 0.35
seconds ON (default)
2: 0.4 seconds ON - 0.2 seconds OFF - 0.4
seconds ON
3: 0.2 seconds ON - 0.2 seconds OFF - 0.2
seconds ON - 0.2 seconds OFF - 0.2 sec-
onds ON
4: 0.2 seconds ON - 0.4 seconds OFF - 0.2
seconds ON - 0.2 seconds OFF
5: 0.25 seconds ON - 0.25 seconds OFF -
0.25 seconds ON - 0.25 seconds OFF
Line 2: Result is shown
MC-MG> SET BURSTPATTERN 5
Burst Ringer Pattern setting succeeded.
Line 1: Enter the Line Number 0-3. And then, enter the
setting value (0-5: default=0) after the space.
Line 2: Result is shown
MC-MG > SET CODEC_COEF 2 0
CODEC Coefficient (CH02) setting succeeded.