NEC SV8500, Manual

Page: 1750 / 3438

VOL.2-1497
MG-SIP128 [MG-128SIPMGJ]
[Setting Example]
Note: Normally this command is not required to be used.
(15) dnsaddress
Setting of the IP address of DNS server
This command is used to specify the DNS IP address to resolve an address by DNS server.
[Setting Example]
Note:
You do not have to change this command if you do not use DNS server.
(16) domain
Setting of DNS domain name
This command is used to specify the domain name of MG-SIP128 [MG-128SIPMGJ].
[Setting Example]
Note: The conditions of this command are as follows.
• Normally this command is not required to be changed.
• To set SIP domain, change the domain name from the “domain name” parameter of “set sip_server” com-
mand or “set_self_sip_domain” command.
(17) drsaddress
Setting of IP address and port number of DRS server
This command is used to assign IP address and port number of DRS server.
MG(SIP) > set default
Are you sure? Y/N=y
Note: When other than “y” is selected,
the following message is dis-
played.
Default setting command was interrupted.
Config data default set.
MG(SIP)>
MG(SIP) > set dnsaddress
Input DNS IP Address.(default=0.0.0.0)
:0.0.0.0 Specify DNS IP address. (Default: 0.0.0.0)
MG(SIP) > set domain
Input Domain Name.(default=0,
MAX128(strings))
:nec.com
Specify the domain name. (Default: 0/Maxi-
mum: 128 bytes)