NEC SV8500, Manual

Page: 2974 / 3438

VOL.3-487
CHAPTER 4 CONFIGURATION SETUP
2. AutoConfig Feature of DtermIP
Note:
“DRS (Device Registration Server)” used in this section refers to the Telephony Server. The Telephony
Server acts as DRS, where DtermIP/IP Enabled Dterm is registered.
2.1 Overview
AutoConfig feature is a method to automatically set the configuration data to DtermIP with a DHCP and FTP
Server.
System
Network
Device
Network
Device
FTP
Server
DHCP
Server
DtermIP
Config File
(1)
(2)
(3)
(4)
(5)
Network
Device : Network Device such as Hub, Router, etc.
System
(1) Create the Config file for DtermIP and store it into the FTP server. Turn the DtermIP ON, and con-
nect it to the network.
(2) DtermIP obtains the FTP server address and the Config file name from the DHCP server.
(3) DtermIP accesses the FTP server and downloads the Config file specified by the DHCP server.
(4) If the downloaded file data is not same as the existing configuration data in the memory of DtermIP,
the downloaded config file data is saved and DtermIP is reset.
(5) After the reset, DtermIP repeats the Step 2 and 3 with the data saved in Step 4. If the downloaded
file data is same as the data in the DtermIP memory, DtermIP can access the System.