NEC SV8500, Manual

Page: 2058 / 3438

VOL.2-1805
MG-SIP16 [SCA-16SIPMGA/MG-16SIPMGA]
7 SET Δ CAUSE_TABLE
The command is used to select the translation table of error cause to be sent to LAN received from SIP
network as error response.
Note:
Assign this setting in accordance with the specifications of connected SIP network.
8 SET Δ CC_CONVERT
This command is used to assign calling party’s country code display conversion feature (since version
09.00.00.00).
When this feature is available, conversion will take place as in the following table.
It is possible to confirm the previous settings through this command since this command is an extension of
the previous version’s SET
Δ
81to0.
Note:
Assign this setting in accordance with the specifications of connected SIP network.
9 SET Δ CDN_PATTERN
The command is used to assign the way of obtaining information for called number from SIP network.
When this command is enabled, a called number is obtained according to the priority order shown in the
table below:
MG(SIP) > set cause_table
Select cause_table(SIP_Error_response to Error_cause)
(0:normal/1:alternate routing(default=0)): _
• Select the error translation table.
0 = Normal table (default)
1 = Alternate routing table
Direction of Call termination/
origination
Intended Number Conversion Feature
Call termination via SIP Calling party Convert to “0” if first numbers are “81” or “+81”
Call termination via SIP
Calling party Add “0” to first number if number is more than 8 digits
Call origination via MG(SIP) Calling party Convert to “0” if first number is “81”
MG(SIP) > set cc_convert
Table 0-2
Is this function enable or disable?
(0:disable/1:enable (default=0)): 0
• Enter 0 or 1 (default=0).
0 = Disable (default)
1 = Enable
Selected Parameter
Order of priority
1 2 3 4 5
0 To
P-N-Dest-
Discern
To (userinfo)
Request-URI
(isub)
Request-URI
(userinfo)
-