NEC SV8500, Manual

Page: 511 / 3438

VOL.2-258
MC & MG with PFT
6.4 Operation and Maintenance
6.4.1 How to Use Maintenance Command
Note:
“DRS (Device Registration Server)” used in this section refers to Telephony Server. Telephony Server acts
as DRS for MC & MG with PFT using Proprietary Protocol.
Note:
When MC & MG with PFT reboots itself due to such as an occurrence of health check timeout while main-
tenance commands are executed, it takes about five minutes to start rebooting.
On a serial connection client (ex. HyperTerminal), start up the program and use maintenance command. Enter
“usrConsole” after the OS prompt (->).
When the maintenance command is started, the following prompt is indicated on the screen:
MC-MG>_ (“machine name” + “>”, usually)
An example of indication is shown below:
MC-ID: 00004ca41cfd
Boot program version: SP3777 MCMG BOOT PROG-A [05.00.00.00]
Main program version: SP3778 MCMG PROG-A [10.00.00.00]
DSP kernel version: DSP-K-AC48104ak[03.10.00.00]
DSP program version: DSP-P-AC48104ae3[03.10.00.00]
DSP kernel version: DSP-K-AC48302ck[03.10.00.00]
DSP program version: DSP-P-AC48302ce6[03.10.00.00]
MUSIC information: SM0901 0900 0000 0000
H/W information: TEST-PKG-MC
H/W information: TEST-PKG-MG
Starting MC-MG Boot program.......
--- Online program Initial start --- (wait 30sec)
Attached TCP/IP interface to axDev unit 0
Attaching interface lo0... done.
Adding 7914 symbols for standalone.
------//----------------------------------------//---
Media Converter - Media Gateway (COT Interface)
*Firmware SP-3778 ( 10.00.00.00 )
*Compiled on Aug 22 2003 11:46:56
---//----------------------------------------//------
->
->
->
->
-> usrConsole
MC-MG Maintenance command Version 1.00 2001.07.19
MC-MG >