NEC SV8500, Manual

Page: 689 / 3438

VOL.2-436
MCMG Card [SCA-7COTA]
•20 milliseconds
•30 milliseconds
•40 milliseconds
•60 milliseconds
Note:
•
If payload type G.711 is specified to more than two priorities in PRI1 through PRI4, assign different
payload size to each priority.
•
When payload types G.723.1 (5.3K
→
6.3K) and G.723.1 (6.3K
→
5.3K) are to be assigned on the same
terminal, specify the same value to the payload size of both types.
•
It is not necessary to assign the payload type/size to the whole priorities. Specifying the first priority
only is allowed.
•
For available payload type/payload size, refer to Peripheral Equipment Description, Volume 1, Chap-
ter 2, “3.1.1 Bandwidth Required for Voice Traffic.”
Setting of PAD: Click the check box to assign the PAD data manually. If not checked, default value 0 is
applied.
KIND2: Specify the PAD value of Analog MC in the range of 0-3.
•No PAD control (determined by ASYD, SYS1, INDEX 4, bit5 (5 dB PAD))
•PAD OFF (0 dB)
•3 dB
•6 dB
KIND3: Specify the PAD No. of IPPAD in the range of 0-15.
PAD value is determined by this PAD No. (0-15) and the setting of SW10-6/7 on IPPAD
card. Refer to the Circuit Card Description for more details.
Setting of Echo Canceller: Click the check box to assign the Echo Canceller data, and select one of the ra-
dio buttons.
•A EC-ON/B EC-ON
•A EC-ON/B EC-OFF
•A EC-OFF/B EC-ON
•A EC-OFF/B EC-OFF
Note:
When the same value is assigned to both “A LOC-ID” and “B LOC-ID” parameters, select either “A EC-
ON/B EC-ON” or “A EC-OFF/B EC-OFF.”
Note:
MC-MG needs to be rebooted after station data is assigned to reflect change. Confirm that there is no con-
versation in progress when rebooting.