NEC SV8500, Manual

Page: 946 / 3438

VOL.2-693
MG-COT Card [SCA-6COTB]
SET COMMAND
1. Setting CODEC Coefficiency
Note:
The setting values are shown in the following table. Set appropriate values. Setting value “2” is assigned
when the product is shipped. Change the data if required.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
2. Setting Default Gateway
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
3. Setting DHCP
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
MG-COT > SET CODEC_COEF_MG P1 P2 Line 1: Enter the Line Number 0-5. And
then, enter the setting value
(default is 2) after the space.
CODEC Coefficient(CH00) setting succeeded. Line 2: Result is shown.
RESISTER KIND OF BNW SETTING VALUE
600 Ω 600 Ω 2 (default)
MG-COT > SET DEFAULTROUTE P1
Line 1: Enter Default Gateway Address.
Default Gateway setting succeeded.
Line 2: Result is shown.
MG-COT > SET DHCP P1 Line 1: Enter ENABLE or DISABLE
after the command name.
ENABLE=DHCP is valid
(default), DISABLE=DHCP is
invalid.
DHCP setting succeeded. Line 2: Result is shown.