NEC SV8500, Manual

Page: 937 / 3438

VOL.2-684
MG-COT Card [SCA-6COTB]
SETUP COMMAND
1. Set up network environment for MG-COT Card Proprietary Protocol mode.
This command is used to setup the basic data for Proprietary Protocol mode. Setting display differs whether
DHCP server is used or not. Assign the required network data following the setting command shown in
dialog form. Be sure to save the entered data at the last of SETUP command.
Note:
The designated operating status cannot refer when SP-3948 6MG COT PROG-A Ver.1.0.0.0 or later.
• When DHCP is used:
Note:
If DHCP server is set for use, DHCP Option will be set for use automatically. If you do not assign the IP
address of DRS to DHCP server, It must be assigned by “SET DRSADDRESS” command individually.
MG-COT > setup tp
MG-ID = xx:xx:xx:xx:xx:xx MAC Address is displayed.
Use DHCP?
Input (Y:Yes / N:No / Q:Quit) : y
Enter “y”.
--------------------------------------
MG-ID = xx:xx:xx:xx:xx:xx
DHCP = ENABLE
--------------------------------------
Input (Y:OK / N:Change / Q:Quit) : y
Enter “y” when the assigned data is cor-
rect.
** Don't power off in progress **
Do you save the configuration data? (Y/N) : y Enter “y” when saved the configuration
data.
Configuration data has not been saved.
Re-starting is required for making a setup
reflect!! Result is shown.
Tp mode setting succeeded.
The register mode will be changed to
TP mode after re-starting.
MG-COT >