NEC SV8500, Manual

Page: 2894 / 3438

VOL.3-407
CHAPTER 4 CONFIGURATION SETUP
1.2 Data Assignment for System having DHCP server - Type 2 [DRS address not assigned]
The following shows the procedure of DtermIP/IP Enabled Dterm data assignment for a system having DHCP
server [DRS address not assigned (
Note 1
)].
Note 1:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
• When using the DHCP server and Redundancy Configuration System such as SR-MGC, refer to
“2.2.1 Setting for Redundancy Configuration System”.
Caution: Observe the following while performing this procedure:
• Do Not Turn OFF the power of the DtermIP/IP Enabled Dterm, the Telephony Server, DHCP
server.
• Do Not Unplug or Plug the LAN cable connecting to the DtermIP/IP Enabled Dterm, the
Telephony Server, DHCP.
• Do Not Turn OFF the power of the HUB connecting to the DtermIP/IP Enabled Dterm, the
Telephony Server, DHCP.
STEP 1: Turn ON the DtermIP/IP Enabled Dterm.
STEP 2: While indicating "Connecting..." or "DRS(1st) Connecting" on the display,
press "Hold" + "Transfer" + "*" + "#" on the terminal, and open the User Menu.
Wait for a while until the following message is displayed on the terminal.
Note 1:
If any data has been assigned to the terminal, the displayed message may differ from the above.
A
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
[User Menu]
DRS(1st) Connecting... DHCP Connecting...
or
Note 2:
When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".
Ex.)
Note 1 Note 1 Note 2