NEC SV8500, Manual

Page: 473 / 3438

VOL.2-220
MC & MG with PFT
13. Route Number of MG (COT) must be different from that of conventional analog COT Card. Route Num-
ber can be shared by multiple MG (COT)s.
14. Assign each LENS for LINE (0-1) and CH (Fixed to 0) in AMGIL command. (LINE 0: Even Number
Level, LINE 1: Level of LINE 0 + 1)
15. Guard Timer for Originating Call is performed by the Telephony Server side. Assign the Timer value by
ASYD (SYS 1, INDEX 474) to change the value. Default value is 3072 milliseconds.
16. When digit conversion is required for the digits received from the public network, use ARTD,
CDN66(DC) and ACDD. A maximum of seven digits can be converted, counting from the last.
17. There are the following restrictions when using REMOTE ACCESS TO SYSTEM [R-2] or AUTO-
MATED ATTENDANT [A-82].
• If Virtual Register cannot be seized, Physical Register is seized. (e.g. RT=902 ORT, RT=903 IRT,
RT=906 PBR for Automated Attendant Service, RT=933 CRT)
• When Virtual/Physical (described above) Register cannot be seized, calling party hears busy tone.
• A maximum of 64 Virtual Registers (
Note 1
) can be used per 1 LP at the same time.
• Assign “2” to EQP of AAED to make calling party hear some announcement. The announcement can
be sent only once.
Note:
“8” or “9” must not be assigned to EQP.
Note 1:
This value includes the followings; RT=902 ORT, RT=903 IRT, RT=906 PBR for Automated Attendant Ser-
vice, RT=933 CRT.
18. System Messages ([33-R], [33-T]) are output when packet transmission failure is detected in Internal PHI-
BRI.
19. Assign the following parameter in ARTI command when using fax via MG (COT).
• CDN 71: IP FAX data
• CDN 72: Jitter Buffer Size for IP FAX
• CDN 73: Payload Type for IP FAX
• CDN 74: Payload Size for IP FAX
20. When a station is connected to outside terminal via MG (COT), the station user can send external/internal
music resources as Music-on-Hold. External/internal Music-on-Hold data is assigned by AMGIL com-
mand per MG (COT).
21. MC&MG does not support Caller ID Display (Number Display). When connecting a terminal having its
function to MG (COT), turned off the function of the terminal.
22. If a call originated from Station (or Trunk) A to Station B is forwarded by Call Forwarding - All Calls [C-
5] to Station C (as a ringdown call via MC-MG(COT)) in busy state, Station (or Trunk) A hears RBT
instead of BT. After 12 seconds, Call Forwarding - All Calls [C-5] is canceled and the call terminates to
the Station B.
23. MG (COT) is not available for OGC/OGCA. For MG (COT), use LCR Access Code.