NEC SV8500, Manual

Page: 399 / 3438

VOL.2-146
8LC Card [SCA-8LCA/SCA-8LCA-EMEA/SCA-8LCC/SCA-8LCC-EMEA]
• Restoring Config Data By Serial Connection And TFTP Connection
STEP 1
Power off 8LC Card and disconnect it from the network.
STEP 2
Connect Serial Console to 8LC Card by using a CONSOLE cable.
STEP 3
Connect TFTP server to 8LC Card by using a LAN cable.
<Data Assignment on TFTP Server>
STEP 4
If the name of the backup config file is not sysdata, rename it to “mc8-sysdata.txt”.
STEP 5
Put the file in the root folder of TFTP server, and then start the TFTP server program.
STEP 6
Permit read behavior of this folder. For more information, refer to the appropriate manual at-
tached to the TFTP server program.
<Data Assignment on Serial Console>
STEP 7
Power on 8LC Card.
STEP 8
Activate HyperTerminal and set the following:
Bit per second: 9600bps
Data bits: 8bit
Parity: None
Stop bit: 1bit
Flow control: None
STEP 9
After a prompt (
->
) is displayed, enter “
usrConsole
”.
STEP 10
After a prompt (
MC(SIP)>
) is displayed, enter “
get configdata <TFTP’s IP Ad-
dress>
” to download configuration data into 8LC Card.
MC1 MC3 MC5 MC7
MC0 MC2 MC4 MC6
ALM PWR
ON
LINE
Ether
OPERATION
MC0 MC2 MC4 MC6
MC1 MC3 MC5 MC7
MC8
100M LINK CONSOLE
RESET
Serial Console
TFTP Server
8LC Card
Note 1
Note 1
: TFTP server and Serial Console both can be performed by single Personal Computer.
CONSOLE cable
LAN cable
Configdata
(1) Control 8LC Card
(2) Download config data via
TFTP