NEC SV8500, Manual

Page: 2926 / 3438

VOL.3-439
CHAPTER 4 CONFIGURATION SETUP
(d) 4. VLAN Priority (PC)
The display changes as follows when “4. VLAN Priority (PC)” is selected.
Set VLAN Priority in the range from 0 to 7 (The default value is 5.), and the press OK key.
Note:
Pressing any key other than 0 to 7is invalid.
To delete an entered character, press BK key.
(e) 5. Port Available (PC)
The display changes as follows when “5. Port Available (PC)” is selected.
Choose one of the following by pressing each digit key, and then press OK key.
0. Automatic: According to the direction from the System. If there is no direction, PC port is
enabled.
1. ON: According to the setting on terminal. (PC port is enabled.)
2. OFF: According to the setting on terminal. (PC port is disabled.)
STEP 8: All the necessary data is set, go back to the User Menu, and then press Save key.
Priority
(0-7)
OK Cancel BK
X
0.Automatic
1.ON
OK Cancel BK
Down
2.VLAN Mode(PC)
Up Down
Exit
1.Speed & Duplex(PC)
1.LAN Port Settings
2.PC Port Settings
Up
Down
Exit
Press Exit key.
Save
1.DHCP Mode
2.DRS Address Primary
Up Down Cancel
[User Menu]
[Port Setting]
Press Exit key. Press Save key.