NEC SV8500, Manual

Page: 1214 / 3438

VOL.2-961
MG-PRI/PRA
13.4 Operation and Maintenance
13.4.1 How to Use Maintenance Command
Note:
“DRS (Device Registration Server)” used in this section refers to the Telephony Server. The Telephony
Server acts as DRS, where MG-PRI/PRA is registered.
Note:
When an event causing a restart of the device, such as health check timeout, occurs during startup of the
configuration command, it takes about five minutes to start the rebooting after you exit from the configu-
ration command or enter the last command.
1. Connect a PC to the MG-PRI/PRA using the RS-232C straight-through cable and run terminal software
(e.g. HyperTerminal) on the PC.
2. Set the parameter of the terminal software as follows:
• Port: COM1
• Baud Rate: 9600 bps
• Data: 8 bits
• Parity: None
• Stop Bit: 1
• Flow Control: None
3. Enter usrConsole after the prompt. Then the following prompt appears.
MG-PRI>_
(Machine Name > : default)
An example of indication is shown below:
The user input command above consists of a several components. The following describes these components
using one of the
set commands.
MG-PRI> set ipaddress 123.50.18.45
IP Address has set
MG-PRI>_
User Input Command
Reply Message
Prompt
PWR
MUSIC
Tx/Rx LINK
LINE
10/100
IMP TNS RCV
MG-2M
-LINE- LB
ON
LINE
B D
to serial port
maintenance console
MG-PRI> set ipaddress axDev0 123
IP Address has set
MG-PRI>_
MG