NEC SV8500, Manual

Page: 902 / 3438

VOL.2-649
MG-COT Card [SCA-6COTB]
Reliability: Place a checkmark to set High Reliability to ON.
MIN Cost: Place a checkmark to set Cost Precedence to ON.
<When DIFFSERV is selected>
Priority: Specify the DiffServ Code Point in the range of 0-63.
Note:
Default settings (IP PRECEDENCE, Priority=6, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Min Cost=OFF) is applied when the check box is not clicked.
AIVCL: Assignment of IP Service Voice Control Data (LDM)
A LOC-ID:Location ID of the self-location [0-4095]
B LOC-ID:Location ID of the destination location [0-4095]
Setting of Jitter Buffer: Click the check box to assign the Jitter Buffer data.
JB_MIN: Jitter Buffer minimum value [0-30 ( × 10 milliseconds)]
JB_MAX: Jitter Buffer maximum value [0-30 ( × 10 milliseconds)]
Note:
Default settings (JB_MIN=1 (10 ms), JB_MAX=30 (300 ms)) is applied when the check box is not clicked.
Setting of Type of Service (Voice Packet): Click the check box to assign the ToS data for voice packet.
IP Precedence/DiffServ: Select either of the radio buttons.
<When IP Precedence is selected>
Precedence: Specify the precedence in the range of 0-7 (low-high).
Low Delay: Place a checkmark to set Low Delay to ON.
Through Put: Place a checkmark to set High Throughput to ON.
Reliability: Place a checkmark to set High Reliability to ON.
MIN Cost: Place a checkmark to set Cost Precedence to ON.
<When DiffServ is selected>
DSCP: Specify the DiffServ Code Point in the range of 0-63.
Note:
Default settings (IP Precedence, Precedence=5, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Min Cost=OFF) is applied when the check box is not clicked.
Setting of Payload: Click the check box to assign the Payload data. Specify the Payload Type and Payload
Size in the order of priority 1 to 4 (PRI1 through PRI4).
Payload Type: Select one of the payload type in the combo box.
•No data
•G.711
•G.729.a
•G.723.1 (5.3K
→
6.3K)
•G.723.1 (6.3K → 5.3K)
Payload Size: Select one of the payload size in the combo box according to the Payload Type.
•No data
•10 milliseconds
•20 milliseconds
•30 milliseconds
•40 milliseconds
•60 milliseconds
Note:
•
If payload type G.711 is specified to more than two priorities in PRI1 through PRI4, assign different pay-
load size to each priority.
•
When payload types G.723.1 (5.3K
→
6.3K) and G.723.1 (6.3K
→
5.3K) are to be assigned on the same
terminal, specify the same value to the payload size of both types.