NEC SV8500, Manual

Page: 1250 / 3438

VOL.2-997
MG-PRI/PRA
18. SHOW
Δ
TCS_E1_1
This command is used to display E1 Dch settings for trunk.
19. SHOW
Δ
TCS_E1_2
This command is used to display E1 settings for trunk.
The current setting is displayed.
- Dch Control (0/1=Disable/Enable)
- Dch Mode (0/1=User/Network)
- Dch Signal Logic (0/1=Positive Logic/Negative Logic)
- Dch 1 (0/1=Disable/Enable)
- Dch 2 (0: Fixed)
- Mode (0/1=Fixed value/Set value)
- Data Transfer Speed (0=64K/1=56K/2=48K)
- Time Slot Number (1-31)
- Dch Signaling Set (0: Fixed)
MG-PRI > SHOW TCS_E1_1
value is 0x9080
Dch Control
:1
Dch Mode :0
Dch Signal Logic :0
Dch-1 Drop/Insert :1
Dch-2 Drop/Insert :0
Drop/Insert Mode :0
Data Transfer Speed :0
Drop/Insert Time Slot :16
Dch Signaling Set :0
The current setting is displayed.
- Multi-frame Remote Alarm (0/1=Enable/Disable)
- Alarm Release Timing (0/1=Short/Long)
- Line Signal (0/1=HDB3/AMI)
- CRC4 (0/1=Disable/Enable)
- DTI Mode (0: Fixed)
- CRC Multi-frame Format (0/1=Disable/Enable)
- Ebit Automatic Sending (0/1=Disable/Enable)
- TS16 Control (0/1=Data Through/Signaling
- Dch Mode (0/1=ITU-T/AT&T)
- Loop Back Pattern (0: Fixed)
- Alarm Detect/Release Type (0/1=ETSI/ITU-T)
MG-PRI > SHOW TCS_E1_2
value is 0x1000
Multi-frame Remote Alarm :0
Alarm Release Timing
:0
Line Signal :0
CRC4 :1
DTI Mode
:0
CRC Multi-frame Format :0
Ebit Automatic Sending :0
TS16 Control :0
Dch Mode :0
Loop Back Pattern :0
Alarm Detect/Release Type :0