NEC SV8500, Manual

Page: 1898 / 3438

VOL.2-1645
MG-SIP96
When Route type = 1 is selected:
When Route type = 2 is selected:
• [To Assign Destination Network Address and Gateway Address]
Usually, gateway data should be set as ‘Static’ at LAN (Telephony Server network) side.
MG(SIP)> set ipx_route
Select Route type(0:Exit/1:None/2:Static):1 0: Exit
1: None (Default)
2: Static
3: Dynamic
Select “1”.
<< Result >>
Route type: None
Are you sure? Y/N=y
Note: Pressing any key other than “y”
causes the following message.
Route setting command was interrupted.
MG(SIP) >
MG(SIP)> set ipx_route
Select Route type(0:Exit/1:None/2:Static):2
0: Exit
1: None (Default)
2: Static
Select “2”.
Select command(0:Exit/1:Set/2:Delete):1
0: Exit (Exit the command without execut-
ing anything.)
1: Set route information.
2: Delete route information.
Select “1”.
Select Gateway type(0:Exit/1:Gateway/
2:Default Gateway):1
0: Exit (Exit the command without execut-
ing anything.)
1: Specify the gateway.
2: Specify the default gateway.
Select “1”.
Input Destination network
Address:172.16.0.0
Specify the network address. Note 4
(Default: 0.0.0.0)