NEC SV8500, Manual

Page: 718 / 3438

VOL.2-465
MCMG Card [SCA-7COTA]
Enter the command, sub command and required parameters after the prompt (MC-MG>) appears. Parameters
vary depending on the kind of command specified. When the data (command name, sub command name, pa-
rameter) is specified correctly, the command executes the required data processing, and then displays the pro-
cessed result on the screen. To finish this program, input EXIT after a prompt.
Note:
When the maintenance command program is activated, it provides a Help Function for referring to avail-
able commands and sub commands. After a prompt is shown, request to list-up the Target Help by entering
“?” or “command name (SET or SHOW) + ?”, and press the Enter key.
The example below shows the screen when requesting a list of SET commands.
MC-MG> SET ?
BURSTPATTERN Setting Burstpattern
CH_ATTRIBUTE Setting CH attribute
DEFAULTROUTE Setting Default Gateway
DHCP Setting DHCP
DRSADDRESS Setting DRS Address
:
: