NEC SV8500, Manual

Page: 1672 / 3438

VOL.2-1419
MG-SIP128 [MG-128SIPMGG]
show
(1) arp
Displaying of ARP table
This command is used to show the Address Resolution Protocol (ARP) table of MG-SIP128 [MG-
128SIPMGG].
[Setting Example]
Note:
Actual values such as Address or HWaddress may differ from this sample.
Note 1:
Address : IP address (IP address or host name of an entry)
Note 2:
HWaddress : Physical address /Hardware address (For Ethernet, MAC address of an entry)
Note 3:
Flags Mask : Entry type (C: Used for normal entries only.)
(2) config
Displaying of a configuration data list
This command is used to show the configuration that has been currently specified for the MG-SIP128
[MG-128SIPMGG].
The following shows a sample display.
[MAC configuration data]
MG(SIP)> show arp
Address
Note 1 HWtype HWaddress Note 2 Flags Mask Note 3 Iface
192.168.0.250 ether 00:1D:92:9E:2A:E0 C eth0
192.168.0.99 ether 00:B0:D0:31:FE:64 C eth0
192.168.0.1 ether 00:30:13:76:7B:52 C eth0
MG(SIP)> show config
[2012-05-05 14:49:29] Time when the configuration is
acquired.
[SP-4051:01.00.00.00] Software version information of
MG-SIP128 [MG-128SIPMGG]
0=MAC Data MAC Data=MAC configuration
data
1=DRS Data DRS Data=Configuration data of
the Telephony Server
2=Common Config Data Common Config Data=Common
configuration data
3=Port Config Data Port Config Data=Port configura-
tion data