NEC SV8500, Manual

Page: 1449 / 3438

VOL.2-1196
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
STEP 5
Set network environment for the TFTP server.
IP Address: 10.41.1.250
Subnet mask: 255.255.255.0
STEP 6
Start the TFTP program.
STEP 7
Power on MG(PRI).
STEP 8
Activate HyperTerminal and set the following:
Bit per second:9600bps
Data bits:8bit
Parity:None
Stop bit:1bit
Flow control:None
STEP 9
After a prompt (“
>MG-PRI
” or “
>MG-PRI
(SIP)”) is displayed, enter “
download
”.
STEP 10
When “
Do you need download?
” message is displayed, enter “
y
”.
STEP 11
The current settings of MG(PRI) are displayed, and then the screen asks you to input TFTP
Server IP Address. Enter a TFTP server IP address.
STEP 12
The current settings of MG(PRI) and TFTP server are displayed. Make sure of the settings.
If you need to modify the settings, select a number (1-4) to modify the item. If all the settings
are correct, enter “
y
”.
STEP 13
Download menu is displayed, and then select “
1
” (Download of all programs).
STEP 14
IP address information setting is displayed, and then select “
1
” (current setting).
STEP 15
Other configuration setting is displayed, and then select “
2
” (current setting).
After download process is completed, MG(PRI) will reboot.
STEP 16
Turn off and on the power of the MG(PRI).
STEP 17
After a prompt (
->
) is displayed, enter “
dispver
” to display the firmware information of
MG(PRI).
STEP 18
After a prompt (
->
) is displayed again, enter “
usrConsole
”.