NEC SV8500, Manual

Page: 2016 / 3438

VOL.2-1763
MG-SIP16
4 SHOW Δ ROUTE
This command is used to show the Route Table.
Note:
Actual value may differ from this sample.
5 SHOW Δ STATUS
This command is used to show a status of the system.
When Port status (=0) is selected:
Note 1:
Port status is displayed as follows depending on the status.
MG(SIP) > show route
ROUTE NET TABLE
Destination Gateway Flags Refcnt Use Interface
--------------------------------------------------------------
10.41.205.0 10.41.205.100 0x101 0 0 dp0
10.41.207.0 10.41.207.100 0x101 0 0 dp1
--------------------------------------------------------------
ROUTE HOST TABELE
Destination Gateway Flags Refcnt Use Interface
--------------------------------------------------------------
127.0.0.1 127.0.0.1 0x101 0 0 lo0
--------------------------------------------------------------
• It may take time to display the route
table information when DSN server
IP address has been assigned.
MG(SIP) > show status
0: Port status
1: IPX status
2: SIP status
9: Exit
Please choose a reference number:_
0: Port status (default)
1: Telephony Server network registra-
tion status
2: SIP network registration status
9: Exit
MG(SIP) > show status
0: Port status
1: IPX status
2: SIP status
9: Exit
Please choose a reference number:0
IPX port link up (100Base-TX/Half)
SIP port link up (10Base-TX/Half)
• When Port Status (=0) is selected:
Note 1
Port Status IPX Network
SIP Network
100M/Half
IPX port link up (100Base-TX/Half) SIP port link up (100Base-TX/Half)
100M/Full
IPX port link up (100Base-TX/Full) SIP port link up (100Base-TX/Full)
10M/Half
IPX port link up (10Base-TX/Half) SIP port link up (10Base-TX/Half)