NEC SV8500, Manual

Page: 1709 / 3438

VOL.2-1456
MG-SIP128 [MG-128SIPMGG]
Note 1:
Before selecting “Y” to save the running configuration data to the Flash memory, be sure to execute
the following commands:
• “set ipaddress”: Assigns the IP addresses on LAN side, and SIP side.
• “set drsaddress”: Assigns the IP address of DRS.
• “set sip_server”: Assigns the IP address of SIP proxy server.
• “set keynumber”: Assigns a pilot number.
If any of these items have not been assigned when saving the running configuration data, the fol-
lowing message will be displayed to the unassigned item. When these messages are displayed, you
can select if you want to set the default configuration data. If you select “Y” here, the default values
are applied to the configuration data.
Note 2: The configuration data is not saved until MG-SIP128 [MG-128SIPMGG] is rebooted.
4. ping
[Function]
To attempt “ping” command five times to the designated IPv4 host on the network.
[Setting Example]
The following setting commands are not
perfect.
“set ipaddress” command.(IPX side)
If IP address for LAN side has not been assigned.
“set ipaddress” command.(SIP side) If IP address for SIP network side has not been
assigned.
“set drsaddress” command. If IP address of DRS has not been assigned.
“set sip_server” command.
If IP address of SIP proxy server has not been
assigned.
“set keynumber” command.
If a pilot number has not been assigned.
So, Config data is made a default
setup.
Is it all right? Y/N=y You can select if you want to apply the default val-
ues to the configuration data.
y: apply default value
n: do not apply default value
If other than the above is selected, the following
message is displayed.
Reboot command was interrupted.
MG(SIP)> ping 172.16.253.3 Enter “ping” com-
mand and designate
the target IPv4
address.
PING 172.16.253.3 (172.16.253.3) 56(84) bytes of data.