NEC SV8500, Manual

Page: 2317 / 3438

VOL.2-2064
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
Note 1:
About IP address of SIP server (Telephony Server), refer to “Registration Destination of IP Devices/Sta-
tions” in INTRODUCTION of Installation Manual.
14. Setting VLANs:
This command assigns VLAN ID and its COS value. When VLAN is enabled in VS-32(Dual), Physical
LAN becomes invalid. IP address, netmask, and Default Gateway settings in physical LAN are succeed
into VLAN.
• When VLAN has not been set yet:
• When VLAN has already been set:
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
VS-32> SET VLAN
Please enter a parameter
VLAN set ENABLE or DISABLE: enable ENABLE=VLAN is used
DISABLE=VLAN is not used (default)
VLAN ID (1-4094) : 5 Enter the VLAN_ID [1-4094]
COS (0-7) : 3 Enter the Class of Service (COS) setting [0-7]
VLAN device setting complete. Result is shown.
VS-32> SET VLAN
VLAN-ID and COS exist already.
Is it all right although overwritten?
[Y(write)/N(current)/Q(quit)]:
y
Y=Overwrite the current setting
N=Not change
Q=Quit this command setting
Please enter a parameter.
VLAN set ENABLE or DISABLE: enable
ENABLE=VLAN is used
DISABLE=VLAN is not used (default)
VLAN ID (1-4094) : 5
Enter the VLAN_ID [1-4094]
COS (0-7) : 3
Enter the Class of Service (COS) setting [0-7]
VLAN device setting complete.
Result is shown.