NEC SV8500, Manual

Page: 1209 / 3438

VOL.2-956
MG-PRI/PRA
STEP 10
Specify CIC Information
Open ACIC1 command and specify the accommodated location of Virtual Control Channel on Point Code.
as follows:
Note:
NDM command (ACIC1N) cannot be used here.
PC: Enter the Point Code specified by ADPC
CSCG: Enter the CSC group specified by ACSC
STEP 11
Specify the trunk data for Dch referring to STEP 7.
Open ATRK command and specify trunk data on Virtual Speech Channel.
STEP 12
Specify Trunk Make-Busy
Open MBTK command to cancel Make Busy of Virtual Speech Channel.
RT: Specify the Route Number
TK: Specify the Trunk Number
MB=0 (Indicates Make-Busy is cancelled.)
STEP 13
Specify MG-PRI/PRA related information
Open
AMGIL
command and register information regarding to MG-PRI/PRA as follows:
MG-ID: Specify the MAC Address (6 bytes)
KIND: Specify an ISDN Trunk (PRI 1.5M / 2M)
LINE=0 (fixed)
CH=0 (fixed)
LENS: Specify a Basic Accommodated Location (top of HW)
Retry: Specify a Retry Number of demanding request for MG-PRI/PRA connection
Service Type: Specify QoS settings of Signaling (indicating ToS when Internal PHI-PRI connects to MG-
PRI/PRA)
STEP 14
Specify MG-PRI/PRA Voice Control Data
Open
AMGVL
command and register the voice control data when connecting to MG-PRI/PRA. If the set-
tings are not specified with this command, the values will be set to “G711” and “40ms” automatically.
A RT (MG Storing): Physical route number of Virtual Speech Channel (connected point)
TYPE: Select one of the followings:
Route Specified
Location ID Specified
B RT (MG Storing)
Displayed when TYPE=Route Specified is selected.
Specify the Physical Route Number (MG)