NEC SV8500, Manual

Page: 803 / 3438

VOL.2-550
MG-COT Card [SCA-6COTA/SCA-6COTC]
<When Proprietary Protocol Mode>
Assign the configuration data for MG-COT Card in Proprietary Protocol mode. About the configuration data for
SIP mode, refer to
page 555 .
STEP 1: When the boot program is started, the initial display below is displayed on the screen.
STEP 2: Type “usrConsole” at the indicated OS prompt and press the ENTER key.
STEP 3: MG-COT command prompt appears as follows.
STEP 4: Type “SETUP TP” to set the network data depending on your LAN environment.
Note 1
There are two ways to set the network data;
• When DHCP server is used
• When DHCP server is NOT used
Note 1:
If the firmware version is earlier than SP-3875 6MG COT PROG-A Ver.3.0.0.0, type “SETUP” to set the
network data.
MG-ID: xxxxxxxxxxxx
Starting Bootprogram......
--- Online program Initial start --- (wait for a while.)
:
:
:
->
->
->
->
->
->usrConsole
->usrConsole
MG-COT Maintenance command
MG-COT>