NEC SV8500, Manual

Page: 3028 / 3438

VOL.3-541
CHAPTER 4 CONFIGURATION SETUP
STEP 5:After assigning each data, press OK key and go back to the PC Port Settings Menu. Repeat Step 3-4
until all the necessary data is set.
STEP 6:When the all necessary data is set, press Exit key on the PC Port Settings Menu to go back to
Advanced Settings Menu.
STEP 7:Press Exit key on the Advanced Settings Menu to return to the Network Settings Menu.
STEP 8:Press Exit key on the Network Settings Menu to return to the Main Menu.
STEP 9:Press Save key on the Main Menu to save the assigned data.
4.1.6.3 CDP Mode
On the CDP Mode parameter, set whether to send the power consumption information to the hub.
STEP 1:Select “6. Advanced Settings” by pressing “6” key on the Network Settings Menu.
Network Settings Menu
Up Down OK
1.Autonego
2.100M Full
3.100M Half
4.10M Full
5.10M Half
Cancel
Cancel OK
2.Enable
1.Disable
Cancel OK
(0-4094)
Port VLAN ID?
XXXX
BK
Cancel OK
(0-7)
Port VLAN Priority?
X
BK
When selecting
“1.Speed & Duplex”:
When selecting
“2.VLAN Mode”:
When selecting
“3.VLAN ID”:
When selecting
“4.VLAN Priority”:
Cancel OK
2.OFF
1.Automatic
When selecting
“5.Port Available”:
Cancel OK
2.Enable
1.Disable
When selecting
“6.EAPOL Forwarding”:
Up Down Exit
11.DHCP Mode
2.IP Address
3.Default Gateway
4.Subnetmask
5.DNS Address
6.Advanced Settings