NEC SV8500, Manual

Page: 2082 / 3438

VOL.2-1829
MG-SIP16 [SCA-16SIPMGA/MG-16SIPMGA]
47 SET Δ SLIPRESP
This command is used to determine a SLIP response code.
48 SET Δ UPDATE
This command is used to enable/disable the use of update method.
Note:
Assign this command adjusting to the specification on SIP network.
49 SET Δ RESPONSE_TABLE
This command is used to set response table.
Note: -
Generally this command is not required to be changed.
-
This command is available for SP-3905 MG SIP (16) PROG-A Issue 3 or later.
50 SET Δ OUT_OF_AREA_CODE
This command is used to set the error response code to inform out-of-area error on the Telephony Server
network side.
Note: -
Generally this command is not required to be changed.
-
This command is available for SP-3905 MG SIP (16) PROG-A Issue 3 or later.
MG(SIP) > set slipresp
SIP Server slip response code?(400-699):_
• Set the SLIP response code (default: 488).
MG(SIP) > set update
Is the UPDATE method support function disable?
(0: disable/1: enable(default=0)):_
• Enable/disable update method.
0: Update method is enabled (default)
1: Update method is disabled
MG(SIP) > set response_table
Select Response_table (Error_cause to SIP_Error_response)
(0:normal/1:revised_table (default=0)):_
• Select the response table pattern
0: Normal table (default)
1: Server error is not sent out from MG-
SIP16 to SIP network
MG(SIP) > set out_of_area_code
Please set up the error response code when the out of
area. (400-606 (default=408)): 408
• Enter the error response code (default: 408)