NEC SV8500, Manual

Page: 1997 / 3438

VOL.2-1744
MG-SIP16
22 SET Δ IPX_RTP_PORT_NO
This command is used to assign the base port number that is used for RTP at LAN side.
Note 1:
The value must be assigned by an even number.
23 SET Δ KEYNUMBER
The command is used to assign a pilot number of MG-SIP16 for registration.
Note 1:
Be sure not to enter a space after the key number.
24 SET Δ MULTI_REGIST
This command is used to enable/disable the setting of registration to SIP server per number.
Note 1:
When “Privacy” is selected, assign a random value to the User ID field of SIP message “Contact header”.
When “SIP-URI” is selected, assign the SIP-URI to the User ID field of SIP message “Contact header”.
Assign the telephone number if SIP-URI has not been assigned.
Note 2:
Use configuration command “set
Δ
sip_register” to assign the SIP server for register destination. The as-
signment of “set
Δ
sip_register” is necessary when registration is to be done per number.
Assign this command adjusting to the specifications on SIP network.
MG(SIP) > set ipx_rtp_port_no
IPX side RTP port number (1024-65024): 51000
• Assign the base port number that is used for RTP at LAN side
(default: 51000).
Note 1
MG(SIP) > set keynumber
Key number(MAX32): 0
• Assign the pilot number when register is performed (default: 0).
Note 1
MG(SIP) > set multi_regist
Enable Multi-registration mode?
(0:disable/1:enable(default=0)): 1
The interval of REGISTER message transmitting
(1-10sec(default=1sec)): 1
Standby timer value(10-3600sec(default=30sec)): 30
Contact header type?
(0: Privacy/1: SIP-URI(default=0)): 0
• .Select disable or enable.
0: disable (default)
1: enable
• Assign the time interval to send register (default: 1sec).
• Assign the time value to re-register after fault recovery
(default: 30sec).
• Assign the header type.
0: Privacy (default)
Note 1
1: SIP-URI
Note 2