NEC SV8500, Manual

Page: 485 / 3438

VOL.2-232
MC & MG with PFT
Note:
The PAD value of MG(COT) is valid only when you select “Setting”from the drop-down box of “Setting of
Detail” to specify the detail PAD value.
AIVCL: Assignment of IP Service Voice Control Data for LDM
Assign the voice packet control data for terminal that is connected to MG (COT).
A LOC-ID
Location ID of MG (COT) or IP terminal
B LOC-ID Location ID of MG (COT) or IP terminal
SETTING OF JITTER BUFFER
JB_MIN:Jitter Buffer Minimum
JB_MAX:Jitter Buffer Maximum
SETTING OF TYPE OF SERVICE (VOICE PACKET)
Type of service for MG (COT)
SETTING OF PAYLOAD
PAYLOAD TYPE
PAYLOAD SIZE
[3] Internal PHE Data Assignment
MC part of MC&MG is controlled by Internal PHE which is embedded in the Telephony Server. About the pro-
cedure for the Internal PHE data assignment, refer to Vol.1, Chapter 2, “2. IP Related Basic Programming” in
this manual. The explanation of PHs including Internal PHE is also there.
[4] MC Data Assignment
Assign the system data, according to the station numbering plan. Refer to the following for the prerequisite min-
imum data.
ASYD: Assignment of System Data
SYS1, INDEX 4, b2-b3
Assign the Releasing Method for Station-to-Station Calling Service
00 = Calling Party release
01 = Called Party release
10 = First Party release
11 = Both Party release
Normally, “10” = First Party release is assigned.
SYS1, INDEX 16
Assign the number level on station number composition
b0: 0/1 = 1-digit station number is not used/used
b1: 0/1 = 2-digit station number is not used/used
b2: 0/1 = 3-digit station number is not used/used
b3: 0/1 = 4-digit station number is not used/used
b4: 0/1 = 5-digit station number is not used/used
SYS3, INDEX 0