NEC SV8500, Manual

Page: 2420 / 3438

VOL.2-2167
SR-MGC
27.3.4 Starting Up SR S of SR-MGC
The following are procedures for setting SR S of SR-MGC.
[1] Flash Card Insertion
STEP 1: Unfasten the screw and remove the front cover on the front panel of SR S.
STEP 2: Insert the prepared Flash card (system program and the license have already
been installed) to the PCCARD slot.
[2] Power Cable Connection
STEP 1: Plug the attached power cable into AC connector on the rear side.
STEP 2: Plug the other side of the cable in a socket.
[3] Power ON
Turn on the power of SR S.
Note:
Do not turn on the power of SR S before SR T.
[4] Lamp Check
When the SR S operates normally, LEDs on the front panel indicate as follows.
-PWR: Lights Green
-ACT:
Lights Green
-ALM: Flashes Red in 2-second cycle (temporary minor alarm indication)
[5] PCPro Connection (Local Connection)
Connect the PCPro PC (PCPro software has been installed) directly to LAN1 port on the front panel of
SR S with LAN cable (crossover).
[6] Connection Check between PCPro PC and SR S
Use ping to test reachability to the SR S. The connections are established when replies are sent back from
the SR S.
[7] Network Settings of SR S
The default settings are in the following:
IP Address 172.16.253.1
Subnet Mask 255.255.255.0
DNS 172.16.253.1
Host Name SRMGC_SP
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required