NEC SV8500, Manual

Page: 1473 / 3438

VOL.2-1220
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
16. SET
Δ
INTERFACE
This command is used to specify the specifications of connection mode. Assign a correct setting corre-
sponding to connecting network equipment. To make this assignment effective, it is required to execute the
“SAVE” command and to restart before exiting the maintenance command.
17. SET
Δ
IPPADDRESS
Δ
P1
Δ
P2
This command is used to specify IP Address and subnet mask for MG. To make this assignment effective,
it is required to execute the “SAVE” command and to restart before exiting the maintenance command.
Note:
The designated IP address cannot be applied when DHCP is set to “Enabled.” Be sure to assign the DHCP
setting to “Disable” before performing this IP address assignment.
Note:
The following are examples that cannot be used in the MG(PRI) setting:
(Example1) Network address cannot be assigned as IP address of MG(PRI).
IP address:192.168.1.0
Subnet mask: 255.255.255.0
(Example2) Broadcast address cannot be assigned as IP address of MG(PRI).
IP address:192.168.1.255
Subnet mask: 255.255.255.0
18. SET Δ ONE_TIME_PASS
This command is used to specify one-time password for SIP Mode. To make this assignment effective, it
is required to execute the “SAVE” command and to restart before exiting the maintenance command.
MG-PRI(SIP)>SET INTERFACE
SPEED(AUTO/100M/10M):100M
1) Select a line speed
AUTO =Auto Negotiation (default)
100M =100M
10M =10M
DUPLEX(FULL/HALF):HALF 2) Select a type of duplex (not displayed when SPEED=AUTO)
FULL =Full duplex
HALF =Half duplex
Ethernet Speed setting succeeded. Result is displayed.
MG-PRI(SIP)>SET IPADDRESS 10.4.1.1
255.255.255.0
P1 -Specify the IP address
P2 -Specify the subnet mask
IP Address setting succeeded. Result is displayed.
MG-PRI(SIP)>SET ONE_TIME_PASS P1 -Specify a password.
One Time Password:
•••••
Erase start...
Erase OK!
Write start...
Write OK!
One time password setting succeeded.
Result is displayed.