NEC SV8500, Manual

Page: 1827 / 3438

VOL.2-1574
MG-SIP128 [MG-128SIPMGJ]
upload
This command is used to upload Multipoint data via Ether1 port (Ether port on the LAN side).
The following figure shows an example of a display.
[Example]
MG(SIP) > upload
Input “upload” in the configuration
mode.
--- Upload menu ---
Upload of mp_data. --- input:1 Specify the information to upload.
Quit --- [Q/q]
Input:1 To upload CSV file, enter “1”.
--- IP Address and Subnet mask setting of
MG(SIP) ---
Select Ether Port [1(Ether1)/2(Ether2)/
Q(quit)]:1 Select Ether port.
(When this feature is used as default
setting, be sure to use Ether 1. When
Ether 2 is used, assign 2 port setting by
“set ipaddress” command.)
Current IP Address of MG(SIP):10.xx.x.xxx
Do you change IP Address of MG(SIP)?
[Y(change)/N(current)/Q(quit)]:y
To change the IP address that is used
for uploading, enter “y”.
If you want to return to the previous step,
please input 'Q'.
Input new IP Address:172.yy.yyy.yyy
Enter the IP address.
Current Subnet mask of MG(SIP):255.0.0.0
Do you change Subnet mask of MG(SIP)?
[Y(change)/N(current)/Q(quit)]:y
To change the subnet mask of the
selected port, enter “y”.
If you want to return to the previous step,
please input 'Q'.
Input new Subnet mask:255.255.0.0
Enter a subnet mask.
--- IP Address setting of TFTP server ---
Current IP Address of TFTP server:10.41.1.250 To change the IP address of a TFTP
server, enter “y”.
(Default address: 10.41.1.250)