NEC SV8500, Manual

Page: 2132 / 3438

VOL.2-1879
MG-SIP16 [SCA-16SIPMG(US)]
22.4.6 Operation Check
Make sure the MG-SIP16 is in normal operation by the following procedure.
STEP 1: Reboot the MG-SIP16 by using
reboot
command.
STEP 2: Make sure the following message appears on the Maintenance Console.
STEP 3: Make sure the registration status of the Telephony Server network and SIP network by using
show
status
command in the console command mode to confirm the network registration status on the
Telephony Server and SIP sides.
Note 1:
For the detailed information, refer to page 1929.
STEP 4: When using PCPro, make sure the registration status of MG-SIP16 by using
DIMG
command.
22.4.7 Trouble Shooting
If the message shown below appears on the console, make sure of the following:
• LAN cable is securely inserted to Ether 2?
• Ether 2: LINK lamp (WAN side - SIP network) lights green?
If no message appears within 3 minutes, it seems that no communication has been established between
the Telephony Server and the MG-SIP16. Check the LAN cable connecting LAN-Telephony Server and
the IP address of DRS.
***************************************
* MG-SIP ONLINE START *
***************************************
MG(SIP) > show status
0: Port status
1: IPX status
2: SIP status
9: Exit
Please choose a reference number:1
MG(SIP) > IPX Registration Information
Registration Done. (DRS IP address 172.16.253.1)
• Select a desired status you want to
check.
Note 1
***************************************
* MG-SIP OFFLINE START *
***************************************