NEC SV8500, Manual

Page: 1037 / 3438

VOL.2-784
MG-BRI
[SAVE CONFIG, EXIT, REBOOT Command]
1. SAVE CONFIG Command
This command is used to save the modified configuration data to the Flash card.
Note:
Configuration data will not going to be saved when error has occurred while executing SAVE CONFIGU-
RATION command.
1. EXIT Command
This command is used to exit the MG-BRI. Save the latest configuration using SAVE command and then
exit from the MG-BRI setting. Confirmation message appears when the configuration has not been saved.
Note:
Key entry will be denied when “EXIT” command was executed by the OS prompt (
→
). In this case, OS
prompt will be displayed again by pressing “Ctrl key” and “C key” simultaneously.
MG-BRI>save config
** Don’t power of in progress **
Do you need save? [Y/N]: Y
Enter "Y" to execute the command.
Preservation of configuration data has been saved.
Result displays.
Re-starting is required for making a setup reflect!!
MG-BRI>exit
Configuration data was changed.
** Don’t power off in progress **
y:Save and Exit
n:Exit without saving
c:Cancel
[y/n/c]:y
Enter "Y" to execute the command.
Configuration data has been saved.
finished!