NEC SV8500, Manual

Page: 2959 / 3438

VOL.3-472
CHAPTER 4 CONFIGURATION SETUP
1. DHCP Mode
2. DRS Address Primary
Up Down
Save Cancel
1. Terminal ID
2. Download Address
Up Down
Exit
Factory Value Set?
Cancel Set
DHCP Connecting... DRS(1st) Connecting...
By pressing the OK key, the display automatically returns to the Administrator Menu.
Caution:
Do not Turn OFF the power of the IP Enabled Dterm before it starts up again.
STEP 9: Open the Administrator Menu by pressing "Hold" + "#" + "0".
STEP 10: Select "0. Factory Value" by pressing "0" key on the Administrator Menu.
STEP 11: "Factory Value Set?" is displayed. Press OK key.
STEP 12: Reassign the configuration data to each parameter.
[User Menu]
[Administrator Menu]
END
B
STEP 8: Wait for a while until the IP Enabled Dterm starts up again.IP Enabled Dterm starts setup process with DRS
on the LAN, indicating "DHCP Connecting.../DRS(1st) Connecting..." on the display. After a while, the current time
is appeared on the display.
1. Terminal ID
2. Download Address
3. DRS Mode
4. PROTIMS Address
5. PROTIMS PORT
6. RTP Address
7. RTP Port
8. Download
9. SoftReset
0. Factory Value
Administrator Menu List
Up
Down
While indicating the current time or an error message on the display,
open the User Menu by pressing "Hold" + "Transfer" + "*" +
"#" on the IP Enabled Dterm.
or
Note:
When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".
Ex.)