NEC SV8500, Manual

Page: 1690 / 3438

VOL.2-1437
MG-SIP128 [MG-128SIPMGG]
(5) route
Displaying of Route table
This command is used to show the Route Table of MG-SIP128 [MG-128SIPMGG].
[Setting Example]
Note: The conditions of this command are as follows.
• Actual values such as Destination or Genmask may differ from this sample.
• It may take time to display the route table information when DNS server IP address has been assigned. (“set
dnsaddress”)
• Settings of “Flags”, “Metric”, Ref”, “Use”, “MSS”, “Window” and “irtt” do not affect the operation of
MG-SIP128 [MG-128SIPMGG] directly.
Note 6: Flags : Indicates a route type. (“U” is usable, “H” is host, “G” is gateway.)
Note 7: Metric : Indicates route metric. (In the range of one to 9999.)
Note 8: Ref : Indicates the number that the route is referred.
Note 9: Use : Indicates the number that the route was actually used (routed).
Note 10: MSS : Indicates the Maximum Segment Size (MSS: Maximum data size of a TCP segment) at
a route.
Note 11:
Window : Indicates a window size of TCP.
Note 12:
irtt : Indicates the initial round-trip time of TCP connections to each route. MG-SIP128
[MG-128SIPMGG] regards a TCP connection where no reply lasts for the round-trip
time (1 to 12000) as no connection.
(6) status
Displaying status of ports and registration
This command is used to show status of ports and registration on MG-SIP128 [MG-128SIPMGG].
[Setting Example]
• If displaying port status
SP-4051 MGSIP PROG-G |SP-4051 |Ver01.00.00.00
Software version information of
MG-SIP128 [MG-128SIPMGG]
MG(SIP)> show route
Kernel IP routing table
Note 5 Note 6 Note 7 Note 8 Note 9 Note 10 Note 11
Destination Gateway Genmask Flags MetricRef Use Iface MSS Window irtt
172.16.0.0 * 255.255.0.0 U 0 0 0 eth1 0 0 0
192.0.0.0 * 255.0.0.0 U 0 0 0 eth0 0 0 0
MG(SIP)> show status