NEC SV8500, Manual

Page: 733 / 3438

VOL.2-480
MCMG Card [SCA-7COTA]
6. Setting FAX enable timer:
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
7. Setting Fax receiver PAD value:
Note:
The FAXRECVPAD command assigns the value to decrease the Fax signal level in the receiver (PSTN to
IP) direction when the Fax signal is detected.
Note:
The total PAD value (Receiver PAD + Fax Receiver PAD) is limited to 20dB.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
8. Setting Fax sender PAD value:
Note:
The FAXSENDPAD command assigns the value to decrease the Fax signal level in the sender (IP to PSTN)
direction when Fax signal is detected.
Note:
The total PAD value (Sender PAD + Fax Sender PAD) is limited to 20dB.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
mand.
Line 1: Enter the Change Effective Timer.
0=Invalid to change to Fax mode
1-5=Possible to change to Fax mode within 1-5
minutes (default=1 minute)
OFF=Always possible to change to FAX mode
Line 2: Result is shown.
MC-MG > SET FAXERRORDETECT_MG 1
FAX Enable Timer setting succeeded.
Line 1: Enter the Fax Receiver PAD value in the range
of 0-20 after the command name (default=0).
Line 2: Result is shown.
MC-MG> SET FAXRECVPAD_MG 0
Fax Receiver PAD setting succeeded.
Line 1: Enter the Fax Sender PAD value in the range of 0-
20 after the command name (default=3).
Line 2: Result is shown.
MC-MG> SET FAXSENDPAD_MG 3
Fax Sender PAD setting succeeded.